ManageRe-mainRoll Barcodes Printer Operation After the Paper is FedOn Not printed Press ▲ or ▼ to select the type and length of paper loaded, and then press the OK button.Note• For details on types of paper to select, see the Paper Reference Guide. (See "Displaying the Paper Refer-ence Guide.") ➔ P.3648 Holding it at the positions indicated, close the Roll Cover.Note• Cut the edge of the roll after the paper is advanced if it is soiled or if there are cuts from scissors or the bladeafter removing creased edges. (See "Specifying the Cutting Method for Rolls.") ➔ P.386Changing the Type of PaperChanging the Type of PaperFollow these steps to change the type of paper specified on the printer after you have loaded paper.If you will continue using this type of paper later, selecting Keep Paper Type > On will save the time and effort of con-figuring the media type setting when you load the paper again. The current media type settings before you select Onwill be automatically selected at that time. (See "Using the Same Type of Paper Regularly.") ➔P.377Important• For best printing results, the printer fine-tunes the print head height and the feed amount for each type of paper. Besure to select the type of paper to use correctly before printing.• Because the printer fine-tunes the feed amount for each type of paper, the margins and the size of printed imagesmay vary depending on the type of paper used. If margins and the size of images are not as you expected, adjust thepaper feed amount.(See "Adjusting the Feed Amount.") ➔ P.529• Rolls and sheets have different printing areas, and sheets having a larger bottom margin than rolls.(See "Print Area.") ➔ P.629Changing the Type of PaperNote• When you load a roll, a menu for selection of the type of paper is shown on the Display Screen. Select the type ofpaper, and then press the OK button.If no barcode has been printed on the roll and you have set ManageRemainRoll to On, specify the roll length after thetype of paper. (See "Specifying the Paper Length.") ➔ P.3781 On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se-lect the Paper tab ( ).Changing the Type of Paper iPF780User's GuideHandling and Use of Paper Handling rolls376
