66 6-66-6Trouble Shooting > Trouble Shooting Items > Image Faults > Paper Creases or CurlsTrouble Shooting > Trouble Shooting Items > Image Faults > Paper Creases or Curls● Printouts Are GrayishCause SolutionIs in Settings> set too dark?Adjust the setting so that density is lighter.Is the printer installed whereit is subject to direct sunlightor strong light?Install the printer in an appropriate location.Was the toner cartridge beenleft in direct sunlight for a longperiod of time?Store the toner cartridge in an appropriate location for twoto three hours, then try printing again. This may solve theproblem. If the problem persists, replace the toner cartridge.● Cannot Scan a Printed BarcodeCause SolutionAre you trying toscan a barcodeprinted with factorydefault settings?In the printer driver, specify [Special Settings 1] for the setting of [SpecialPrint Mode].NOTE:• WhWhen set to [Special Settings 1], print density is lightercompared with [Off]. Text and lines may also appear faded.• White specks may appear in images printed on paper other thanlightweight paper with this feature set to .F-6-11T-6-10F-6-12T-6-11■ Paper Creases or Curls● Paper CreasesCause SolutionIs paper loadedcorrectly?If paper is not loaded below the load limit line or is loaded obliquely, it maycrease.Are you using paperthat has absorbedmoisture?Replace with appropriate paper.Are you usingappropriate paper?Check usable paper, and replace with appropriate paperIf the problem persists after using appropriate paper, change the setting for.[Menu] > [Adjustment/Maintenance] > [Special Processing] > [SpecialMode V] > Select the mode● Paper CurlsCause SolutionAre you usingappropriate paper?Check usable paper, and replace with appropriate paper. Also, specify thepaper size and type settings properly.If using Plain (16 to 24 lb Bond (60 to 90 g/m²)), changing [Paper Type] in theprinter driver to [Plain L] may solve the problem.If the use of the appropriate paper does not solve the problem, change thesetting for .[Menu] > [Adjustment/Maintenance] > [Special Processing] > [SpecialMode V] > Select the modeF-6-13T-6-12F-6-14T-6-13
