313 Starting the Viewerz In order to retrieve information, you must be connected to aMaster Storage Server, even if it is on the same computer as theViewer.z After installation, the Master Storage Server is set to ‘localhost’.This indicates that the Viewer will attempt to use the localcomputer as its Master Storage Server.NoteAfter installation, the default user ‘admin’ with the password ‘NVR’is setup. It is strongly recommended that this is changed afterinstallation.TipIf you clicked the Cancel buttonduring launch, the Connect toMaster Storage Server dialog willappear.A different Master Storage Servercan be selected by overwriting theexisting Host Name or IP addressand Port number with another.Setting the Master Storage ServerIf you are unsure of the address to use, see your System Administrator.z Enter a Storage Server address and Port numberEnter a Host Name or IPaddress for a new MasterStorage Server, then enter thePort number.Click Connect to continue.12If you installed the Viewer and Storage Server on separate PCs, be sure to configure aMaster Storage Server in the first place. By default, the Master Storage Server is set to‘localhost’.Changing the Storage Server
