1-11Setting the Administrator Password, LAN, IPv6, DNS, etc. (Network)11 Detailed SettingsSNMP(1) [SNMP]Select whether to use SNMP from [Disable] or [Enable]. When [Enable] is selected, the SNMPManager can reference information set in the camera.(2) [Community Name]Set a community name for SNMP. It is recommended that you change the default communityname to ensure security of the system.(3) [Administrator Contact Information]Set contact information (e-mail address, etc.) for the Administrator of the camera. Thesettings can be referenced by the SNMP Manager.(4) [Administration Function Name]Set the camera name used for administration. The settings can be referenced by the SNMPManager.If this field is left blank, "VB-C60" will be used by default.(5) [Installation Location]Set information regarding the installation location of this camera. The settings can bereferenced by the SNMP Manager.Tipz The information set in the camera is read-only from the SNMP Manager.z Use the SNMP Manager SNMP MIB2 (supporting RFC1213).z The camera's SNMP does not support IPv6.COPY
