IJ Scan Utility Lite Error MessagesIf an error message for IJ Scan Utility Lite appears, check the error code and follow the correspondingsolution.Error Code Error Message Solution152 There is not enough memory. Exit other applications to increaseavailable memory.• The memory required tostart IJ Scan Utility Litecannot be obtained; exitother applications.153 The image you attempted to scan is in a size that cannot be openedin the specified application. Change the settings so that the imagesize is reduced.• Reduce the resolution oroutput size and scanagain.157 Cannot communicate with scanner for these reasons:- Scanner is turned off.- (If using Wired LAN connection) It is disconnected from WiredLAN.- (If using wireless LAN connection) Signal strength is poor due toobstructions.- Network connection is prohibited by security software.- Different scanner on the network is selected.Check the above and try scanning again.If you still cannot communicate, restart the computer.• With network connection,check the connectionstatus and reconnect asneeded. If the same errormessage still appears,restart the computer.201 A required file is missing or corrupted, or settings are incorrect.Try the installation again.• Reinstall the scannerdriver from our website.• Reinstall IJ Scan UtilityLite from our website.202 An internal error has occurred. Take the following measures.- Check the scanner status.- Restart the scanner.- Restart the computer, then try again.- Reinstall the scanner driver.• An internal error has oc-curred. Take the follow-ing measures.◦ Check the scannerstatus.◦ Restart the scanner.◦ Restart the comput-er, then try again.◦ Reinstall the scannerdriver.231 Cannot complete the scan. The disk space is insufficient. • Delete unnecessary fileson the hard disk andscan again.232 Cannot complete the scan. The disk space is insufficient. • Cancel the write protec-tion on the disk.234 This scan function is not supported by the selected model. Select adifferent scan function.• Select a different scanfunction.342
