Canon Remote FAX Kit-A1 Service Manual

Contents

Canon Remote FAX Kit-A1 Service Manual Manual pdf 8 page image

11 1-31-3Specifications > Specifications > Receive Function > Receiving:Specifications > Specifications > Receive Function > Receiving:SpecificationsSend FunctionSending:Using the PCFAX system, you can send fax image data from the unit on which the RemoteFax Kit is activated to a unit with a fax board.The unit with a fax board sends faxes to the destination by standard fax operation via thetelephone line.Once the Remote Fax Kit is activated, configure the settings for connecting to the anotherunit (with a fax board).On the another unit (with a fax board), set the [Use Remote Fax] setting to [On].Receive FunctionReceiving:Use the following procedure to receive faxes on the unit without a fax board.Perform receiving/forwarding from the unit with a fax board (imageRUNNER ADVANCE orconventional model).[iFAX function] -> unit on the same network (imageRUNNER ADVANCE or conventionalmodel).Using the receive/forward setting on the unit with a fax board, specify the unit with theactivated Remote Fax Kit.•••F-1-1F-1-1ImportantIf only the receiving function is needed, an iR unitwith iFAX functionality can be used.In the case that Remote FAX sends result to FAX when reception completes (Full Modefunction) and performs communication without a mail server, Direct MDN is required.In the case of performing communication via a mail server without need of sendingresult, Direct MDN is not required.It is supported from iR C5180/4580/3880 Series or later series.When specifying address using IP address format, it is necessary to put an IP addressin brackets like 123@[172.16.1.100].F-1-2F-1-2