Canon PIXMA mini260 Photo Printing Manual

Also see for PIXMA mini 260: Easy Setup instructions

Contents

Canon PIXMA mini260 Photo Printing Manual Manual pdf 72 page image

70 TroubleshootingCamera Error Message Try ThisPrinter in use z Images are being printed from the computer.Wait until printing ends. The printer automatically starts printing theimages from the camera after completing the current printing.z If the printer is warming up, wait until warm-up ends. When it isready, the printer starts printing automatically.No paper Load the paper in the Auto Sheet Feeder, and select Continue*1in the display on your camera.Paper jam Select Stop in the display on your camera to stop printing.Remove the jammed paper, load new paper, and press the OKbutton on the printer and retry printing.The Paper Thickness Leverposition is incorrect.Set the Paper Thickness Lever to the right. If paper is scratched,set the Paper Thickness Lever to the left. Return the PaperThickness Lever to the right after printing.Printer cover open Close the Printer Cover on the printer.No printhead The Print Head is defective or not installed.Install a Print Head according to the Easy Setup Instructions(Setup Sheet).If the Print Head has already been installed, remove the PrintHead and reinstall it. If the error still remains, the Print Head maybe defective. Contact the Canon service representative.Waste tank (ink absorber) full/Ink absorber fullThe printer has a built-in ink absorber to hold the ink used duringPrint Head Cleaning, for example, This error message indicatesthat the ink absorber is nearly full.You can continue printing for a while by selecting Continue*1 inthe display on your camera.However, because printing is disabled once the ink absorberbecomes completely full and until the ink absorber is replaced,you are recommended to contact a Canon service representativeas early as possible (You will need to replace a particular part ofthe printer).No Ink An ink tank is not installed properly, or is out of ink.Confirm the error message displayed on the LCD and take theappropriate action to resolve the error.Ink error An ink tank that was once empty is installed.Replace the ink tank and close the Printer Cover.Printing with an ink tank that was once empty may damage theprinter.If you want to continue printing in this condition, you need torelease the function for detecting the remaining ink level. Pressand hold the Stop/Reset button for at least 5 seconds, and thenrelease it.* With this operation, releasing the function for detecting theremaining ink level is memorized. Please be advised that Canonshall not be liable for any printer malfunction or damage causedby refilled ink tank.