Canon PIXMA iP4000 Series Start Here Manual

Also see for iP4000 - PIXMA Photo Printer: Supplementary guide Quick start guide Quick start guide Instruction manual Service manual

Contents

start here

Canon PIXMA iP4000 Series Start Here Manual Manual pdf 1 page image

Paper SupportTop CoverPaper Output TrayInner CoverNOTE: The printer will perform a print headcleaning. Wait until the POWER lamp displaysa steady green light before proceeding.clickInstall the Ink TanksUnpack the Printer1 2 3 4 5Prepare the Printer Install the Print Head Connect the Printerand Load PaperStart HereEasy Setup Instructions iP4000 SeriesPhoto PrinterInsert the ink tank into the correct slot.(Refer to the color guide on the print head holder).Press down until the ink tank clicks into place.Remove the shipping tape from the paperguide. Pinch the paper guide and slide it tothe left. Load a few sheets of blank paperinto the auto sheet feeder, then slide thepaper guide toward the left edge of the paper.3clickPaper GuideAuto SheetFeederSlide the print head into the holder.The print head will rest at a slight angle.Remove the print head from its package.Remove the orange protective capfrom the print head.NOTE: Do not touch the print head nozzlesand the electrical contacts.Lower the print head lock lever and pressit down until it clicks into place.Raise the print head lock lever.Electrical ContactsPrint Head NozzlesTear at notch to openInner CoverTop CoverFront CoverSerial NumberLocationPIXMA iP4000 SeriesPhoto PrinterCarefully remove all items from the box.Documentationand Software KitPeel back the orange tab and completelyremove the plastic wrapper from the CyanInk Tank (BCI-6C).Twist off and discard the orange protective cap.Insert the remaining four ink tanks intotheir assigned slots.Close the inner cover, then the top cover.Lift open the paper support and extend thepaper output tray.Power CordPIXMA iP4000 SeriesPrint HeadInk TanksBCI-6Y Yellow BCI-6M MagentaBCI-3eBK Black BCI-6C CyanBCI-6BK BlackContinue with Step 6on side two.NOTE: To avoid spilling ink, never presson the sides of an ink tank.IMPORTANT: Be sure the printer isoff before continuing, or the computerwill attempt to install the printerdriver before the printer is ready.Protective cap145431212345For Parallel Port:For USB Port:TURN THE PRINTER OFF.Connect one end of the parallel cable tothe computer, the other to the printer.12TURN THE PRINTER OFF.Connect one end of the USB cableto the computer, the other to the printer.12USB PortUSB CableUSB PortUSB CableParallel CablePlug the power cord into the back of theprinter and connect the other end to apower outlet. Press the POWER button.The printer will initialize.Remove all shipping tape and clear plasticfrom the printer.21Lower the front cover. Raise the top cover.Remove the shipping tape and lower theinner cover.The print head holder automatically movesto the center. Remove the protective tape.Write down the serial number located tothe right of the print head holder. You willneed this later to register the product.345

/ 2

Related manuals for Canon iP4000 - PIXMA Photo Printer