|
*1: The counter for the on-arrival cleaning is checked at opening and closing of the scanning unit (the first opening andclosing only), before start of printing, at dot-count cleaning (at paper ejection), and at manual cleaning, and the on-arrival cleaning is performed according to the counter value. After each on-arrival cleaning, the counter value isreduced by 1.When the counter value is 3, 2, or 1: On-arrival cleaning is performed.When the counter value is 0: On-arrival cleaning is not performed.*2: When 24 to 60 hours have elapsed since the previous Black cleaning, timer cleaning - 0 is performed. However,this cleaning will be conducted up to 5 times from the printer installation, and no further timer cleaning - 0 will beperformed.*3: The period of time since the previous cleaning is counted by Black and Color separately. For this reason, thecleaning mode may differ according to Black or Color.*4: When only the black ink tank is replaced, Black cleaning is performed. One of the color ink tanks is replaced, Colorcleaning is performed. Both the black and color ink tanks are replaced, All-at-the-same-time cleaning is performed.(All in sequence)At ink tankreplacement *4(Black/Color/All insequence)When an ink tank is replaced (without the printhead removal or re-installation)0.38 (Black)1.00 (Color)80 (All insequence)40 (Black)60 (Color)Manual cleaning(Black/Color/All at thesame time)- Via the operation panel (All at the same timeonly)- Via the MP driver (Selectable from Black,Color, or All at the same time)0.20 (Black)0.50 (Color)45 (All at the sametime)35 (Black)45 (Color)Deep cleaning(Black/Color/All at thesame time)Via the MP driver (Selectable from Black,Color, or All at the same time)1.95 (Black)1.00 (Color)90 (All at the sametime)50 (Black)60 (Color)If the print head has notbeen capped beforepower-on(All in sequence)0.38 (Black)1.00 (Color)80 (All insequence)To the table of contents To the top2-4
PreviousNext |