47Routine MaintenanceAn error message may be displayed on the LCD during printing.z With the Ink LampsYou can confirm the status of each ink tank by the ink lamps. Open the Scanning Unit (Printer Cover)of the machine to confirm how the ink lamps light or flash.z Ink lamp is onThe ink tank is correctly set and there is enough ink remaining to print.z Ink lamp is flashingFlashing slowly (at around 3-second intervals)Ink is low. You can continue printing for a while, but we recommend you to have a new inktank available.Flashing quickly (at around 1-second intervals)The ink tank is inserted in the wrong position or it is empty. Ensure that the ink tank is in thecorrect position as directed by the label on the Print Head Holder. If the position is correct andits lamp flashes, it is empty. Replace it with a new one.z Ink lamp is offThe tank is not set properly. Press the mark on the ink tank until the tank clicks into place.If it does not click into place, make sure that the orange protective cap has been removedfrom the bottom of the ink tank. See “Prepare the replacement tank.” on page 49.If the lamps are still off after reinserting the ink tanks, there has been an error and themachine cannot print. Check the error message displayed on the LCD. See “An ErrorMessage Is Displayed on the LCD” on page 70.Ink has run out. See “The following ink has run out. Replace theink tank.” in “An Error Message Is Displayed on the LCD” onpage 70 and take appropriate action.(B)(B) Empty ink tank.......Repeats......Repeats
