Canon PIXMA MP500 Service Manual

Also see for PIXMA MP500: Supplementary guide Specification sheet Start here User guide User guide

Contents

Canon PIXMA MP500 Service Manual Manual pdf 19 page image

*1: Before replacement of the logic board ass'y, check the waste ink amount (by service test print or EEPROMinformation print). If the waste ink amount is 7% or more, also replace the ink absorber kit (QY5-0146) whenreplacing the logic board ass'y.[See Section 3-3. Adjustment / Settings, (5) Service mode, for details.]*2: Replace the print head only after the print head deep cleaning is performed 2 times, and when the problempersists.No ejection of black ink. - Replace the- logic board ass'y *1 ,- ink tank, or- print head *2 .- Remove foreign material from the purge unit caps,if any.- Replace the purge unit.Graphic or text is enlarged onprintouts.When enlarged in the carriage movementdirection:- Clean grease or oil off the timing slit strip film- Replace the- timing slit strip film,- carriage unit, or- logic board ass'y *1 .When enlarged in the paper feed direction:- Clean grease or oil off the timing slit disk film- Replace the- timing slit disk film,- timing sensor unit, or- logic board ass'y *1 .Faulty scanning No scanning. - Confirm the connection between the scanner unitand the logic board ass'y.- Replace the- scanner unit, or- logic board ass'y *1 .Streaks or smears on the scannedimage.- Clean the platen glass.- Confirm the connection between the scanner unitand the logic board ass'y.- Replace the- scanner unit, or- logic board ass'y *1 .To the table of contents To the top1-13