Canon NP2120 Service Manual

Also see for NP-2020: Service manual

Canon NP2120 Service Manual Manual pdf 26 page image

- ,.GENEWLDESCRIPTION M->.s. ,~B. Making Copies1) Tum the POWER switch ONIf the temperature of the fixing assembly isbelow the specified value,. NP2020The COPY START key remains red.. NP2120The COPY START key flashes green.If the temperature of the fixing assembly isabove the specified value, the COPY STARTkey goes green.The wait time is normally 90 sec (2O”C,average).2) Openthecopyboardcover,andplaceadocumentface down aligning ti with the size index.3) Press the DIRECT, REDUCE, ENLARGE, orZOOM key for the desired copy size.4) Press the AE key, and press the COPY DENSITYkey as necessary if manual adjustment is desired.5) Check the size of the cassette.0 Replace the cassette if it does not containpaper of the desired size.6) PresstheTENKEY padtosetthedesirednumberof copies (1 to 99), and check the COPY COUNTindicator.0 Press the CLEARBTOP key 10 correct anymistake; set the copy count thereafter.7) Press the COPY START key.@ If the CLEARISTOP key is pressed in thecontinuous copy operation. the copier stopsafter it has completed the copy run.@ The adjustment mode for density may beswitched from automatic to manual betweenwhen the operation is started and when thelast copy is completed; however, switchingfrom manual to automatic is not possibleduring the period.Note:If the copy is too dar& or light in the AE mode,de- activate the AE mode, and make copieswhile varying the density using the COPYDENSITY key.@ If the ADD PAPER indicatorcomesONdur¡ngcopy operation and the operation stops, addpaper to the cassette; a press on the COPYSTART key thereafter causes the copier tomake the remaining number of copies.@ IfanADFisattachedtothecopier.documentsplacedonthetraywill beautomaticallypickedupandcopiedwhentheCOPY STARTkeyispressed.l-10 COPYRIGNT % 1992 CANON INC. C A N O N NPZl20/ZMO RN.1 OEC. 1992 PAINTEO I N J A P A N IIMPAIME AU JAPONI0 After each copy operation or a key operation,the copier returns to the standard mode ti leftalone for about 2 min’.‘Cannot be changed. but may be de-activated.C. Using the Manual Feed Tray(NP2020)1) Set a document on the copyboard.2) Press the DIRECT, REDUCE, ENLARGE, orZOOM key.3) De-activate the AE mode, and adjust the densityusing the COPY DENSITY lever if manualadjustment is desired.4) Feed a sheet of copy paper along the guides onthe manual tray.0 The copier automatically starts copying assoon as it detects the copy paper.0 Make sure sheets are fed at intervals of 50mm or more if in the continuous copy mode.Note:When the ADD PAPER indicator is ON, theCOPY READY indicator is red; manual feedoperation, however, is still possible.. Using the Manual Feed Tray(NP21 20)1) Set the document on the copyboard.2) Open the manual feed tray.3) Set the slide guide to suit the paper size.Note:Slide out the sub tray as necessaty to suitlarger paper sizes.4) Insert as many sheets as necessary along theguide until they stop; keep the face of the copypaper up.E. Making Two-Sided CopiesMake sure that the copy is oriented the same way(front and rear) for both first and second sides: keepthe following in mind:0 Check the paper is not moist or curled;0 Check the paper is of 64 to 128 g/mZ;