Canon NP2120 Service Manual

Also see for NP-2020: Service manual

Canon NP2120 Service Manual Manual pdf 148 page image

INSTALLATION BBZ3E. Checking the Imageitep work Remarks1 Place the Test Sheet on the copyboard, Check that copies are made without a problem and theand check the image. non-image width along the leading edge is correct;othelwise, make adjustments.Non-image width:2.0 mm/0.08 ir! (approx.) for leading edge2.5 mm/O.l in (approx.) on left/right side2 Feed paper in the manual mode. Make tow-sided and overlay copies, and check that theoperation is correct; otherwise, make adjustments.Check pick-up by the multifeeder (NP2120).3 Put the OPERATOR’S MANUAL in thepocket of the copyboard cover.4 Clean up the area around the copier, andfil1 out the Service Sheet.When all above work is finished, install the options (ADF-Al, MS-Al, Sorter-Al, Stapler Sorter-Bl , StaplerSorter-BP, andlor Control Card) and the document holder.W Points 10 Note for Photosensitive Drum AiterInstallationThe photosensitive drum is susceptible to lightand, if exposed to light, can cause white spots orblack lines on the copy image; take note of thefollowing:Donottouchthedrum;if itssurfaceissoiled,wipeoff the dirt using a flannel cloth coated with toner. Donot use paper, lint-free or otherwise, or use a drycloth or solvent.- Limit the replacement of the CT unit within oneminute;- Limit the removal of jams within five minutes; and- Keep the drum wrapped in the light-blockingsheet (from drum unit) or fresh copy paper andplace it in a dafk place whenever it is removedfrom the copier.COPYRIGNT G 1992 CANON INC. CAHON NPZl20/2MO RN.2 OEC. 1992 PRINTEO IH JAPAN IIMPRIME AU JAPONI 5 - 7