Chapter 1313-513.2.2 SSSW-SW02:13.2.2.1 Function List 0014-6096i-SENSYS MF4150 / i-SENSYS MF4140 / i-SENSYS MF4120 /T-13-113.2.2.2 Bit 2 and 3 Elaborated 0014-6097i-SENSYS MF4150 / i-SENSYS MF4140 / i-SENSYS MF4120 /If errors resulting from RTN signal transmission occur frequently while receiving, increase the parameter and ease the RTN transmission condition.The RTN transmission condition is defined as a percentage of the number of error lines in the total number of lines of a received image page.It is a combination of Bit 2 and Bit 3 and the percentages are shown below.T-13-213.2.2.3 Bit 5 Elaborated 0014-6105i-SENSYS MF4150 / i-SENSYS MF4140 / i-SENSYS MF4120 /If 'displayed' is selected, an item is added to the user data so that the message language can be changed. By doing so, the language in which messages displayed onthe screen and printed on the reports can be selected from a list of languages.13.2.3 SSSW-SW0413.2.3.1 Function List 0014-6107i-SENSYS MF4150 / i-SENSYS MF4140 / i-SENSYS MF4120 /T-13-313.2.3.2 Bit 8 Elaborated 0014-6110i-SENSYS MF4150 / i-SENSYS MF4140 / i-SENSYS MF4120 /An alarm can be set to go off when the transmission has been completed without a problem. Change the setting to ON in order to activate this alarm.13.2.4 SSSW-SW1013.2.4.1 Function List 0014-6098i-SENSYS MF4150 / i-SENSYS MF4140 / i-SENSYS MF4120 /T-13-4Bit Function 1 01 Not in Use - -2 RTN Transmission Condition 1 0*3 RTN Transmission Condition 1 0*4 Not in Use - -5 Change the Message Language Displayed Not displayed6 Not in Use - -7 Not in Use - -8 Not in Use - -(Bit2, Bit3)= (0, 0) 10%(1, 0) 15%(0, 1) 20%(1, 1) 25%Bit Function 1 01 Not in Use - -2 Not in Use - -3 Not in Use - -4 Not in Use - -5 Not in Use - -6 Not in Use - -7 Not in Use - -8 Alarm at the Completion of Transmission ON OFF *Bit Function 1 01 Alarm at Termination due to Error ON * OFF2 Page Timer in Manual Sending 8 minutes No Limit *3 Not in Use - -4 Not in Use - -5 Not in Use - -6 Not in Use - -7 Not in Use - -8 Not in Use - -