Chapter 33-353.1.17.8 Removing the NCUBoard and Modular Board 0006-30431) Remove the two connectors [1] and the flat cable[2].2) Remove the four screws [3] and remove the NCUboard [4] and modular board [5].F-3-1493.1.17.9 Removing the NCUCase 0006-30451) Remove the three screws [1]; then, pull the upperportion of the NCU case [2] toward you, and liftingit upward, remove the NUC case.F-3-1503.1.17.10 Removing theScanner Unit 0006-30461) Remove the screw [1] and remove the connector [2]as well as the flat cable [3] on the DCNT board.Remove the tape holding the cable in advance.Prepare a new tape (Part No: AZ7-0008) of a suitablelength before you attach the cable again.F-3-1512) Remove the two front screws [1].F-3-1523) Remove the two screws on the back [1]. Slide thescanner unit [2] to the back; then, remove it bylifting it.F-3-153[1][4][3][3][2][5][3][1][2][2] [1][3][1][2][1]
