Canon LV-7575 User Manual

Contents

39SETTINGThis function allows you to customize the screen logo with Logoselect, Capture, and Logo PIN code lock functions.Logo PIN Code Lock Dialog BoxQuitPointerAfter a correct Logo PIN code is entered, the following dialogbox appears.Select On/Off by pressing the POINT LEFT/RIGHT buttons orchange the Logo PIN code.LogoThis function prevents an unauthorized person from changing theLogo setting.Off . . . . the Logo setting can be changed freely from the Logofunction.On . . . . the Logo setting cannot be changed without a LogoPIN code.If you want to change the Logo PIN code lock setting, enter aLogo PIN code by following the steps below. The initial Logo PINcode is set to “4321” at the factory.NOTE:• Before capturing an image, select Standard in the IMAGE SELECT Menu tocapture proper image. (See pages 29, 33.)• A signal from a computer can be captured up to XGA (1024 x 768).• Certain signals may not be captured properly.• When capturing the image that has been adjusted by the Keystone function, theadjusted data is automatically reset and the projector captures an image withoutkeystone correction.• When starting to capture a new image, the previously stored image is cleared evenif you cancel the capturing.• Once you exit the Logo Menu after setting the Logo lock to "On," you are requiredto enter the PIN code every attempting to change the Logo setting.Select [Yes] tocapture theprojected image.This function decides the start-up display as follows:User . . . the image you capturedDefault . the factory-set logoOff . . . . count-down onlyThis function enables you to capture the image being projectedand use it for a starting-up display.After capturing the projected image, go to the Logo selectfunction and set it to “User.” Then the captured image will bedisplayed when turning on the projector the next time.To capture the image, select [Yes]. To cancel the Capturefunction, select [No].CaptureLogo PIN code lockTo Enter a Logo PIN codeSelect a number by pressing the POINT LEFT/RIGHT buttons andfix the number with the OK button. The number changes to “✳.”If you fixed a wrong number, move the pointer to “Set” or“Clear” once by pressing the POINT DOWN button, then returnto “Logo PIN code.” Enter the correct number.Repeat this step to complete entering a four-digit number.When the four-digit number is fixed, the pointer automaticallymoves to “Set.” Press the OK button so that you can change theLogo PIN code lock setting.If you entered a wrong Logo PIN code, “Logo PIN code” and thenumber (✳✳✳✳) turn red and disappear. Enter a Logo PIN code allover again.To Change the Logo PIN codeLogo PIN code can be changed to your desiredfour-digit number. Select “Logo PIN code change”with the POINT DOWN button and press the OKbutton. Set a new Logo PIN code. Be sure towrite down the new Logo PIN code and keep it athand.Select [Yes] to stopcapturing.Logo selectLogoNOTE:If you forget your Logo PIN code and unable to changeit, the Logo PIN code can be reset to the factory defaultsetting (4321) according to the following procedures.When you reset the Logo PIN code, the PIN code andKey lock will be reset, as well.1. Unplug the AC Power Cord from the AC outlet.2. Hold down the OK button on the projector andconnect the AC Power Cord into the outlet again.Keep holding down the OK button until the POWERindicator lights. The Logo PIN code returns to thefactory default setting while the Logo PIN code lockstate will remain the same as the previous set state.