Canon High Capacity Stacker-G1 Operation Manual

Contents

Canon High Capacity Stacker-G1 Operation Manual Manual pdf 18 page image

Filling scenariosFilling scenariosScenario Description Where to define the settings?Filling with defaultsettingsThe stack tray is filled until thestack reaches the factory defaultheight of 302 mm (11.9"). Thenthe stack is ejected.Next job, next tray Each new job is delivered to anempty stack tray.On the printer control panel: [Sys-tem] -> [Setup] -> [Workflow profile]-> [Output] -> [Next output tray] ->[After each job].Maximum tray filling To optimize the productivity,you can set the stack height tomaximum 355 mm (14.0").Due to curl and an uneven tonercoverage of sheets, a slantingstack can occur. This can resultin sheets falling off the stackduring the ejection becausethese sheets can touch the un-derside of the slide door.See the section 'Set the maxi-mum stack height'.In the Settings Editor: [Preferences] -> [Print job defaults] -> [Stacker] ->[Maximum stack height].Limit the stack height According to your needs, ifstacks must fit into boxes for ex-ample, you can define a stackheight below the factory defaultvalue.See the section 'Set the maxi-mum stack height'.In the Settings Editor: [Preferences] -> [Print job defaults] -> [Stacker] ->[Maximum stack height].Filling level This setting is used to keep setstogether.See the section 'Set the mini-mum filling level'.In the Settings Editor: [Preferences] -> [Print job defaults] -> [Stacker] ->[Minimum filling level].Filling scenarios18 Chapter 4 - Use the stacker Canon High Capacity Stacker-G1