Canon FB630U User Manual

Also see for CanoScan FB 630U: Service manual User guide User guide Product guide

Contents

Canon FB630U User Manual Manual pdf 9 page image

9Quick Start InstructionsThose who wish to start scanning immediately should follow the procedures below. Ifyou require further information at any stage, read the pages referenced at each step.Installing Plug-in Module CS-U p. 131. Place the Macintosh version of the CanoScan Setup CD-ROMthat came with the scanner into the computer’s CD-ROM drive.The CanoScan Setup Utility will automatically start. (If theCanoScan Setup Utility does not automatically start, double-click the [CanoScan FB630U/636U] icon, followed by the[Setup] icon.)2. Click [Install the Software] and install Plug-in Module CS-U.(Install Adobe PhotoDeluxe 2.0 first.)If Adobe PhotoDeluxe 2.0 has not yet been installed, install itbefore Plug-in Module CS-U.Start Plug-in Module CS-U p. 191. Connect the scanner to the computer, then start AdobePhotoDeluxe 2.0.2. Select [CanonPI CS-U 3.3.0...] as the image source (this step isonly required the first time the scanner is used with theprogram)3. Click the scanner icon.• Plug-in Module CS-U will start and display its control panel.Start the Preview Scan p. 211. Place the materials to be scanned on the scanner.2. Click the preview scan button ( ).• The entire document glass area will be scanned and displayed in thepreview scan window.Preview WindowPlug-in Module CS-U automatically calibrates itself the first time the preview orscan button is clicked. The scanner will run by itself for a few moments withoutdisplaying an image in the window. This does not constitute a breakdown. Thecalibration results are stored until the computer power is shut off.112233ß