Canon EOS C100 Instruction Manual

Also see for EOS C100: Brochure & specs Basic guide Setting up

Contents

Canon EOS C100 Instruction Manual Manual pdf 45 page image

3 45RecordingRecording VideoThis section explains the recording basics. Before you begin recording, make a test recording first to check if thecamcorder operates correctly. Record for approximately 15 minutes at the default bit rate, 24 Mbps (LPCM)(A 51). Should the camcorder fail to operate correctly, refer to Troubleshooting (A 144).For details on recording audio, refer to Recording Audio (A 74).Preparing to Record1 Attach the handle unit, grip unit, etc. as necessary to build the desiredconfiguration (A 29).2 Attach a charged battery pack to the camcorder (A 22).3 Insert an SD card into an SD card slot (A 39).• Insert another SD card into the other SD card slot to use relay recording(A 41) or double slot recording (A 41).4 Attach a lens (A 29).5 Adjust the viewfinder.Recording1 Set the Q switch to CAMERA (A 24).• The camcorder turns on in mode and enters record pausemode.• At first, both SD card access indicators will illuminate in red. After amoment, the access indicator of the SD card slot selected forrecording will turn green and the other access indicator will go out.Operating modes:Rear tally lampAccess indicatorsCOPY