291If there is a problem with the camera, anerror message will appear. Follow the on-screen instructions.* If the error still persists, write down the error No. and contact your nearestCanon Service Center.Error CodesNo. Error Message & Solution01Communications between the camera and lens is faulty. Clean thelens contacts. Clean the electrical contacts on the camera and lens and use aCanon lens (p.13, 16).02Card cannot be accessed. Reinsert/change card or format cardwith camera. Remove and insert the card again, replace the card, or format thecard (p.32, 48).04Cannot save images because card is full. Replace card. Replace the card, erase unnecessary images, or format the card(p.32, 48, 215).05The built-in flash could not be raised. Turn the camera off and onagain. Operate he power switch (p.28).06 Sensor cleaning is not possible. Turn the camera off and on again. Operate he power switch (p.28).10, 20,30, 40,50, 60,70, 80Shooting is not possible due to an error. Turn the camera off andon again or re-install the battery. Operate the power switch, remove and install the battery packagain, or use a Canon lens (p.26, 28).Error No.Countermeasures
