Chapter 44-164.3.6 NCP Transmission errors 0008-4686T-4-6Message Error code Cause RemedyNo message #022 Address deleted or invalidated duringtransmission reservation.- Retransmit deleted address.- Check that a group address is specified as thetransfer destination and that it contains a validaddress.- Check that a group address is specified as thetransfer destination and whether it contains localprint or fax box only.- Check whether the specified transferdestination address has been deleted.Transmissioncancelled#099/ #995 - Transmission cancelled by user. Resend.Address doesnot appear inaddress list.#704 - An error occurred when addressinformation was being obtained from theaddress list. (Address deleted from list afterscanning, etc.)- Check address list settings. Or, turn unit OFF/ON.HD full #702 Operation stopped because HD full (workarea).- Wait a while then retry. Stop broadcasttransmission with other protocols. Thissometimes helps to avoid this problem.HD full #703 Operation stopped because HD full (imagearea).- Wait a while then retry. Stop broadcasttransmission with other protocols. Thissometimes helps to avoid this problem.Address tablenot available.#706 - Address table being imported/ exportedfrom RUI.- Address book usage doubled up with othertransmission component (Fax, etc.).- Quit access from RUI.- Wait a while and then retryNo response #751 - Server has not booted up.- Network disconnected. (If connectioncannot be made with transmissiondestination, connection is sometimes cutmid-way.)- No Tree name entered.- Reset caused by internal error. Processinginterrupted.- Check transmission destination and networksettings.- Enter Tree name.- Transmission jobs whose processing hasstopped for some reason or other are forced toquit by assigning an internal error code (#751).As a result, after rebooting, the job is not run.Net Wareerror#756 NetWare option is turned off in AdditionalFunctions.Turn NetWare option on in Network Settings,System Settings, Additional Functions.Check server #801 - Error generated due to cause on serverside.- In NetWare, a user exists but no read orwrite privileges.- Transmission made to write-prohibitedfile of the same name.- Reset server.- Check server status and settings.- Check the network traffic.Checkaddress#804 - No match for specified directory name.- No access privileges to the directory.- Check that the destination directory name iscorrect.- Set directory access privileges in the server.- Send to different directory with accessprivileges.Checkaddress.#806 - Wrongly specified user name.- Wrongly specified password.- In NetWare, the host name is incorrect.- Change address book user name or password.No message #807 No access rights for the specified directory - Check the access rights to the server.Noconnection#815 - Login is made from this unit in NetWare'sPserver mode (NDS/ Bindery common) andlogin is attempted again for NCP, while theserver is printing.- Wait a while and try again.- Change the destination NetWare server.- Stop Pserver.
