Chapter 44-15TCP/IP error #755 - IP address set to 0.0.0.0. Inthe following two situations,the IP address is 0.0.0.0.1) Address could not beobtained from DHCP,BOOTP, RARP.2) Unit launched in IP fixedmode(keys 1+7 to enterFIXIPmode).- TCP/IP protocol stackresources insufficient. Evenwith internal retry (5 times),transmission failed.- Set the IP address correctly or set DHCP, RARP,BOOTP environments to operate properly.- Turn power OFF/ON.Check server #801 - Error generated due to causeon server side.- In NetWare,a user exists butno read or write privileges.- Transmission made to write-prohibited file of the samename.- Reset server.- Check server status and settings.- Check the network traffic.Cannot findserver#802 - The IP address for DNSserver is not set up.- DNS Server is not running.- No appropriate host name isfound in the DNS server.- Check the DNS server.Checkaddress#804 - No match for specifieddirectory name.- No access privileges for thatdirectory.- Check that the destination directory name is correct.- Set directory access privileges in the server.- Send to different directory with access privileges.Checkaddress.#806 - Wrongly specified username.- Wrongly specified password.- In NetWare, the host name isincorrect.- Change address book user name or password.No message #807 No access rights for thespecified directory- Check the access rights to the server.Noconnection#815 - Login is made from this unitin NetWare's Pserver mode(NDS/ Bindery common) andlogin is attempted again forNCP, while the server isprinting.- Wait a while and try again.- Change the destination NetWare server.- Stop Pserver.Message Error code Cause Remedy