Canon CXDI-31 Service Manual

2 Installation Manual- 31 -4.3.5. Checking the Sensor Serial No.(1) Purpose1) When the A/D boot loader is installed, the sensor serial number (image file name)written in the flash ROM of the A/D board can be erased. Therefore, the sensor serialnumber must be checked.2) Also, if the sensor serial number stored in the flash ROM of the A/D board differs fromthe image data file name stored in the hard drive of the control PC during installation,the connected sensor can not be detected after the CXDI application is launched. In thatcase an error message appears.(2) Notes1) This checking procedure should always be performed in the following cases.1 When the A/D boot loader has been rewritten during installation.2 When the A/D board has been replaced.3 When the sensor in the imaging unit has been replaced.2) This checking procedure cannot be performed with only the control PC.Connect the imaging units and other equipment, and then start up in the normal imagingstatus.(3) Procedure1) Connect the keyboard and mouse to the control PC.2) Use the capture board interface cable to connect P1 on the capture board to PORT1(COM3) on the serial board.* For more information on connections, see “Hyper Terminal Settings”.3) Start up the CXDI system.* Start up the CXDI application. If the CXDI application is not started up, you cannot go to the checking steps.4) When the normal imaging screen is displayed on the operation unit, start up HyperTerminal for settings.* For the settings, see “Hyper Terminal Settings”.5) After making the HyperTerminal settings, press the [Enter] key on the keyboard.* In the following steps, always press the [Enter] key after making the keyboardinput.

/ 209

Related manuals for Canon CXDI-31

Canon CXDI-80C Service Manual

Canon CXDI-Pro Instructions For Use Manual

This manual is suitable for:

CXDI-31

Canon CXDI-31 Service Manual

Product

Learn More

Legal