CHAPTER 6 IMAGE FORMATION SYSTEM6-84 COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.1 JAN. 2000 PRINTED IN JAPAN (IMPRIME AU JAPON)K. Developing DriveAssembly1. Removing the Developing DriveAssembly and the DevelopingAssembly Rail1) Remove all developing assemblies.2) Remove the rear cover, right upper cover,and right rear cover.3) Remove the flywheel.4) Disconnect the four connectors [1], andremove the two screws [2]; then, detachthe potential measurement PCB.5) Open the CPU PCB.6) Remove the drive assembly reinforcingplate.Figure 6-6827) While lifting the tension plate [3] by hand,detach the drive belt [4].Figure 6-6838) Remove the two screws [6].Figure 6-684[1][1][2][2][4][3][6][6]
