Chapter 5: Preparing for installation Configuring Link for TestPage 5-17Perform the following procedure to toggle the computer to not use the proxy setting.Procedure 3 Bypassing browser proxy settings to access module web pages1 Launch Microsoft Internet Explorer2 Select Tools, Internet Options, Connections, LAN Settings. Alternate web browsermenu selections may differ.3 Uncheck the Use a proxy server box.In the address bar of your browser, enter the IP address of the AP/BHM. (For example, enterhttp://169.254.1.1 to access the AP/BHM through its default IP address). The AP/BHM respondsby opening the General Status tab of its Home page.Logging into the web interface – AP/SM/BHProcedure 4 Logging into the web interface1 Plug one end of a CAT 5 Ethernet cable into the AP/BHM2 Plug the Ethernet cable connector labeled To Radio into the jack in the pig tail that hangsfrom the power supply.3 Plug the other connector of the pig tail (this connector labeled To Computer) into theEthernet jack of the computing device.4 Plug the power supply into an electrical outlet.WarningFrom this point until you remove power from the ODU, stay at least as farfrom the ODU as the minimum separation distance specified in Minimumseparation distances on page 5-3.Using the Quick Start Configuration Wizard of theAP/BHMSee section Quick link setup on page 7-11.
