Chapter 3: Configuration Guide Configuring a Link Using the Quick Configuration Wizardphn-3963_008v000Page 3-47. In the TX Frequency (MHz) field, set the transmission radio frequency in MHz.8. In the RX Frequency (MHz) field, set the received radio frequency in MHz.9. In the TX Level (dBm) field, enter the desired TX signal level (TSL). The range of values depends on thefrequency and RFU type.10. To mute the TX output of the radio, select Mute in the TX mute field. To unmute the TX output of the radio,select Unmute.11. Click Next. Page 4 of the 1+0 Quick Configuration wizard opens.Figure 29 1+0 Quick Configuration Wizard – Page 412. In the Script ID field, select the MRMC script you want to assign to the radio. For a full explanation of choosingan MRMC script, see Configuring the Radio (MRMC) Script(s).1 In the Operational Mode field, select the ACM mode: Adaptive or Fixed.o In Adaptive ACM mode, TX and RX rates are dynamic. An ACM-enabled radio system automaticallychooses which profile to use according to the channel fading conditions.o Fixed ACM mode applies constant TX and RX rates. However, unlike regular scripts, with a Fixed ACMscript you can specify a maximum profile to inhibit inefficient transmission levels.2 Do one of the following:o If you selected Adaptive in the Operational Mode field, the following two fields are displayed:o Maximum profile – Enter the maximum profile for the script. See Configuring the Radio (MRMC) Script(s).o Minimum profile – Enter the minimum profile for the script. See Configuring the Radio (MRMC) Script(s).NoteThe default minimum profile is 2.o If you selected Fixed in the Operational Mode field, the next field is Profile. Select the ACM profile for theradio in the Profile field.3 Click Next. Page 5 of the 1+0 Quick Configuration wizard opens.
