Cambium Networks PTP 850E User Manual

Also see for PTP 850E: Installation guide

Contents

Cambium Networks PTP 850E User Manual Manual pdf 207 page image

Chapter 7: Quality of Service (QoS) Configuring Egress Shapingphn-3963_008v000Page 7-337. Click Apply, then Close.To assign a different queue shaper profile to a queue:1. Select Ethernet > Interfaces > Logical Interfaces. The Logical Interfaces page opens (Figure 118).2. Select an interface in the Ethernet Logical Port Configuration table and click Shaper. The Logical Interfaces –Shaper page opens, with the Egress Queue Shaper Configuration table open by default (Figure 149).3. Select an interface in the Ethernet Logical Port Configuration table and click Shaper. The Logical Interfaces –Shaper page opens, with the Egress Queue Shaper Configuration table open by default (Figure 149).4. Select the row you want to edit and click Edit. The Egress Queue Shaper Configuration – Edit page opens. Thispage is similar to the Egress Queue Shaper Configuration – Add page (Figure 150).5. To assign a different egress queue shaper profile, select the profile in the Profile ID field.6. To enable or disable egress queue shaping for the selected queue, select Enable to enable egress queueshaping for the queue, or Disable to disable egress queue shaping for the queue.7. Click Apply, then Close.