Cal Spas Gazebos Owner's Manual

Cal Spas Gazebos Owner's Manual Manual pdf 15 page image

2008 Gazebo Owner’s Manual Page 13LTR20081011, Rev. ASpa Cabana Gazebo AssemblyStep 2: Anchoring the MainSupport PostWhen scoring the concrete, make sure that the markis dark enough to see, as you will be drilling a hole inthe concrete. This hole will be where the anchoringbolt is located. Also, it is the owner’s responsibility toobtain a 1/2” masonry bit. This bit will be used to drill theanchoring holes in the foundation. A masonry bit may bebought at any local hardware store.Refer to the figure for steps 1 through 3.Pre-drill the anchoring hole using a 1/2” masonrydrill bit. Drill the hole to a depth of no less than 3”.Using a hammer, insert the anchoring bolt by gentlytapping the bolt into place. Continue to tap intoplace until the anchoring bolt is seated securely inthe hole.After drilling the hole and inserting the anchoringbolt, slide the main support post assembly on to theanchoring bolt and tighten down using the providedhardware.Repeat these steps for all four corners of thegazebo.1.2.3.Anchor post into concrete as shown.Concrete FoundationAnchoring BoltGalvanized "L" Bracket4"x 4" PostDetermine spacing of post with spa sizebefore anchoring into concrete.2" x 6" BoardAnchoring BoltGalvanized "L" Bracket2" x 6" Board4"x 4" PostSide ViewFront ViewConcrete FoundationAnchor post into concrete as shown.Concrete FoundationAnchoring BoltGalvanized "L" Bracket4"x 4" PostDetermine spacing of post with spa sizebefore anchoring into concrete.2" x 6" BoardAnchoring BoltGalvanized "L" Bracket2" x 6" Board4"x 4" PostSide ViewFront ViewConcrete Found