Setting Radio Station PresetsTo set preset radio stations, do the following:1. Press the power/volume knob to turn the system on.2. Press the BAND hard key.3. Select the desired band (AM, FM1, FM2, XM1, orXM2 (if equipped)).4. Seek, scan, or tune to the desired stations usingthe seek and scan hard key arrows or thetuning knob.5. Press and hold one of the six preset screen buttons,at the bottom of the screen, until you hear a beep orsee the station displayed on the selected presetbutton.6. Repeat the steps for each preset.See “Preset Stations” under Navigation Audio Systemon page 3-2 for more information.Setting the TimeTo set the time, do the following:1. Press the power/volume knob to turn the system on.2. Press the CONFIG hard key.3. Press the H (clock) screen button.4. Select the 12hour or 24hour screen button todisplay the time in standard or military time.5. Select the AM or PM screen buttons.6. Select the appropriate time zone screen button.7. Select the Daylight Saving Time screen button,if necessary.8. Press and hold the hour and minute arrow buttons toincrease or to decrease the time or press the GPSTIME screen button to reset radio time to GPS time.The radio will use the GPS satellite to set the time. Thevehicle needs to be in an open area to receive the signal.See “Clock” under Configure Menu on page 2-52 formore information.1-7