Menu
Cabela's 18868 Owner's Manual And Installation Manual
           | |
12C h a r g i n g Yo u r B a t t e r i e s / M a i n t e n a n c eO v e r v i e wverviewt Charger is an Advanced Electronic and Fully Automatic Multi-Stagerine Battery Charger. ProSport is pre-wired for easy installation andrproof for fresh and salt water applications.equential Multi-Stage Charging process delivers three sequencedration that include: Charging, Conditioning, and Maintenance of eachprocess is proven to extend the life of your batteries and will fullybatteries each time.eavy Duty extruded aluminum housing delivers increased power andwhile providing improved durability and heat transfer.t's Distributed-On-Demand ™Charging Technology will automaticallystribute 100% of the available charging amp output, 8,12,or 20 ampsfic) to any one battery or combination of all batteries. Each batteryut is fully isolated.sy to view LED indicators will provide at a glance status of: AC power,, Charging, and Ready Status. The LED Status Center can be seen onunit when installed.rt Waterproof Marine Battery Chargers are designed for any combination7,30 and 31 batteries. Each Battery Charger DC output cable must beone (1) 12 Volt DC battery (even if batteries are configured for 24 VoltDC trolling Motor or System Applications). Most specifically you do notve series or parallel jumper cables to use your ProSport Charger. Seediagrams for these systems in the installation section of this manual.application is for 4D or 8D large capacity batteries, please refer towebsite www.promariner.com and view our ProTech-i and ProNauticy Compartment Chargers. Using our online selector guide, choose ast fits your application for this class of batteries.Owner's Periodic Maintenance GuideItem:Process:When:Battery ConnectionsClean and tighten all battery connections. Follow battery manufacturer'sinstructions for cleaning a battery. Clean all battery terminals with awire brush where required and tighten all battery connections.MonthlyItem:Process:When:Battery ElectrolytePer battery manufacturer’s instructions, monitor, and maintainproper levels of distilled water in each battery.MonthlyItem:Process:When:ProSport DC Output WiringVisually inspect all wiring for cuts and abrasions. ContactProMariner if your charger needs to be serviced with new wiring.MonthlyItem:Process:When:AC Power Cord and Mounting Hardware InspectionVisually inspect the AC power cord. Confirm ground blade is presentand all plug blades are in good condition and not bent out of place.Check all mounting hardware to ensure there is no loosehardware. Tighten where required.MonthlyOptional Battery Bank Status MonitorSee your local dealer or retailer for the ProMariner Remote Battery Bank Status Monitor.The Remote Monitor is easy to install and connects directly to your boat’s batteries. Onceinstalled, simply hold down the "Push-To-Test" button and observe the charge level indicatorfor each battery (up to 3 batteries can be monitored).Note: AC power and the boat’sengine must be off when using the Remote Battery Bank Status Monitor.Important Notice: FCC Class A Part 15 Notification.Your ProSport On-Board Marine Battery Charger has been designed and tested to comply with FCCClass A part 15. These regulations are to provide adequate protection against harmful interferencewhile operated in a commercial application. If in a residential setting, you are encountering interferencewith TV and radio reception, simply remove AC power from the ProSport to confirm if your batterycharger is causing interference. End user can explore the following to minimize interference:1) Chose a different AC circuit to power your On-Board Marine Battery Charger.2) Make sure your outlet is properly grounded.3) Re-position receiving antenna.4) Purchase a separate AC line filter.5) Relocate charger so that it is at the furthest point from home receiving equipment,TV, radio, etc. |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved