Menu
CAKEWALK Sonar V-STUDIO VS-700 Getting Started Manual
                                                                | |
Contents
| 
37Initial SettingsIn order to record audio, you must connect your instruments and mics to the VS-700. Here are some typical ways tomake connections.* The VS-700 provides mic preamps and compressors on each of the eight audio inputs (INPUT 1–8). You can produce afatter sound by applying a compressor to the input signal from the mic or other audio source. For details, refer to the“VS-700R I/O” chapter in the VS-700 Owner’s Manual.Recording Audio1. Connect Instruments and MicsVS-700R Rear PanelVS-700C Front PanelVS-700R Rear PanelConnecting a Mic The VS-700R provides a balanced (XLR) type connector thatis wired as shown in the illustration. Check the wiring ofyour device before connecting it.When using a condenser mic that requires a balanced (XLR) connection thatsupplies phantom power, set [+48] button ON (PHANTOM ON).When using a dynamic mic etc. that has a phone plug, set [+48] button OFF(PHANTOM OFF).You must leave the phantom power turned off unless you’ve connected a condenser mic thatrequires a phantom power supply. Supplying phantom power to a dynamic mic or audio playbackdevice will cause malfunctions. For details on the specifications of your mic, refer to the owner’smanual for your mic.Connecting a Guitar or BassConnecting Synthesizers or Audio EquipmentFor a guitar or bass,select the “Hi-Z” setting.If you want to connect a guitar or bass directly, connect it to theAUX IN jack located on the front panel of the VS-700C console.If you want to connect equipment such as a synthesizer or effects processor, useaudio cables to connect the output connectors of such devices to the VS-700R’sINPUT jacks (1, 2).The eight audio inputs (INPUT 1–8) contain phantom power supplies. From SONAR’s“Tools” menu, open “VS-700” and select the “MIC PRE” tab, and click [+48] button tomake settings. When the system is powered up, the phantom power will be turned off.When you load a project in SONAR, the state that is saved in the project will be reflected.Use this to adjust the recordinglevel.Mics with phone plugsMics with phone plugsMics withbalanced (XLR) plugsVS-700C Front PanelFor a mic,select the “NORMAL” setting.Use this to adjust the recordinglevel. |
Related manuals for CAKEWALK Sonar V-STUDIO VS-700
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved