Menu
CAB PX Series Operator's Manual
                            | |
Contents
| 
20 207 Fault Correction7.3 Error Messages and Fault CorrectionError message Cause RemedyADC malfunction Hardware error Switch the print module off and then on.If error recurs call service.Barcode error Invalid barcode content, e.g. alpha-numeric characters in a numericalbarcodeCorrect the barcode content.Barcode too big The barcode is too big for the allocatedarea of the labelReduce the size of the barcode or move it.Battery low Battery of the PC card is flat Replace battery in the PC card.Buffer overflow The input buffer memory is full and thecomputer is still transmitting data.Use data transmission via protocol (preferablyRTS/CTS).Card full No more data can be stored on thememory cardReplace card.Device not conn. Programming addresses a non-existentdeviceEither connect this device or correct theprogramming.File not found Requested file is not on the card Check the contents of the card.Font not found Error with the selected download font Cancel current print job, change font.FPGA malfunction Hardware error Switch the print module off and then on.If error recurs call service.Head error Hardware error Switch the print module off and then on.If error recurs replace printhead.Head open Printhead not locked Lock printhead.Head too hot Printhead is overheated After pausing the print job will be continuedautomatically. If the fault recurs repeatedly,reduce the heat level or the print speed viasoftware.Invalid setup Error in the configuration memory Re-configure print module.If error recurs call service.Memory overflow Current print job contains too muchinformation, e.g. selected font, largegraphicsCancel current print job.Reduce amount of data to be printed.Name exists Duplicate usage of field name in thedirect programmingCorrect programmingNo DHCP server The print module is configured forDHCP, but there is no DHCP server,or the DHCP server is not currentlyavailable.Switch off DHCP in the configuration, and assigna fixed IP address.Please contact your network administrator.No label found There are labels missing on the labelmaterialPress pause key repeatedly until print modulerecognizes the next label on the material.The label format as set in the softwaredoes not correspond with the real labelformatCancel current print job.Change the label format set in the software.Restart print job.No label size The size of the label is not defined inthe programming.Check programming.No Link No network link Check network cable and connector.Please contact your network administrator.For operation without network connection setparameter "Network error" to Off Configuration Manual.No record found Refers to the optional memory card;database access errorCheck programming and card contents.No SMTP server The print module is configured forSMTP, but there is no SMTP server,or the SMTP server is not currentlyavailable.Switch off SMTP in the configuration.Caution! Then a warning cannot be sent bye-mail (EAlert).Please contact your network administrator. |
Related manuals for CAB PX Series
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved