Bosch WAW28520TH Instruction Manual And Installation Instructions

Also see for 8 Series: Instruction manual Recipes Instruction manual Installation instructions Assembly instructions

en Operating the appliance38Change the programmedefault settingsYou can use or change the defaultsettings for this washing cycle.To do this, repeatedly press thecorresponding button until the requiredsetting is displayed.Note: Pressing and holding the buttonautomatically runs through the setvalues to the end. Then press the buttononce more and you can then changethe setting values again.The settings are activated withoutneeding to be confirmed.The settings are not saved afterswitching off the washing machine.Default programme settings~ Page 34Select additional programmesettingsBy selecting additional settings, you canbetter adapt the washing process toyour items of laundry.The settings can be selected ordeselected depending on theprogramme progress.The button indicator lamps light up if asetting is activated.The settings are not saved afterswitching off the washing machine.Additional programme settings~ Page 35Start the programmePress the Ü button. The indicator lamplights up and the programme starts.The display panel shows the "Ready in"time while the programme is running orthe programme length and theprogramme progress symbols when thewashing programme has started.Display panel ~ Page 25Note: Foam detectionIf the o symbol also lights up in thedisplay panel, the washing machine hasdetected too much foam during thewash programme and automaticallyactivated additional rinse cycles toremove the foam.Add less detergent to the next washingcycle with the same load.If you want to lock the programme toprevent it from being inadvertentlyadjusted, you can select the childprooflock as follows.Child lock. E 3 sec.You can lock the washing machine toprevent the functions you have set frombeing changed inadvertently. To do this,activate the childproof lock.To activate/deactivate, press and holdthe Ready in ñ - and + buttons at thesame time for approx. three seconds.The w symbol is appears in thedisplay panel.■ w lights up: The childproof lock isactive.■ w flashes briefly: The childprooflock is active and the programmeselector was turned or a button waspressed.Note: The childproof lock remainsactive, even once the washing machinehas been switched off. Before selectingthe next programme, deactivate thechildproof lock.