en Installation and connection40Removing the applianceAlso observethe sequence of worksteps here.1. Disconnect the appliance fromthe power supply.2. Turn off the water supply.3. Undo the waste water and drinkingwater connection.4. Loosen fastening screws forthe furniture parts.5. If fitted, remove the base panel.6. Pull out the appliance, carefullypulling the hose behind.TransportationEmpty the dishwasher and secure looseparts.Drain the appliance accordingto the following steps:1. Turn on the tap.2. Open the door.3. Switch on ON/OFF switch (.4. Select programme @ withthe highest temperature button <H.5. Press START button h.6. Close the door.Programme sequence starts.7. Open door after approx. 4 minutes.8. Press START button hfor approx. 3 sec.The Cleaning display X goes out.9. Close the door.The remaining programme sequencelasts approx. 1 minute more. (Buzzersounds.)10.Switch off ON/OFF switch (.11.Turn off the tap, disconnect supplyhose and drain water.Transport appliance upright only.(This prevents residual water fromrunning into the machine controland damaging the programmesequence.)Protection against frostProtection against frost (Emptying the appliance)If the appliance is in a room where thereis a risk of frost (e.g. holiday home),empty the appliance completely (seeTransportation).6XEMHFWWRFKDQJHV