Menu
Bosch Rexroth AGEV1-48404-AA/HM/L01H01-XC Operating Instructions Manual
                                        |
12/40 Safety instructionsBosch Rexroth AG, Manifold block type AGEV1-48404-AA/HM/L01H01-XC, RE 62272-B/03.192.6 Product-specific safety instructionsWARNINGEasily inflammable hydraulic fluid!In connection with a potentially explosive atmosphere or other heat sources,leaking hydraulic fluid mist due to defective or incompletely installed manifoldblocks and their connections may lead to explosions.▶ Only use the manifold block in the explosion protection area intended for it.▶ The ignition temperature of the hydraulic fluid used must be 50 K higher thanthe maximum surface temperature (200 °C).▶ Use only hydraulic fluids that are approved for the manifold block.Risk of explosion as a result of electrostatic discharging processes!When hydraulic fluids with low electrical conductivity are used, electrostaticcharging of the hydraulic fluid may occur, especially during filtering.▶ To prevent hazardous electrostatic discharging, an electrical conductivity of thehydraulic fluid of at least 300 pS/m has to be envisaged.▶ Take appropriate measures for dimensioning and designing hydrauliccomponents such as pipes, filters and tanks so that hazardous electrostaticdischarges of the hydraulic fluid can be ruled out.▶ Ground all electrically conductive system parts!Exceedance of the maximum temperatures!Using the manifold block outside the approved temperature ranges may lead tomalfunction. This means that explosion protection is no longer ensured.▶ Only use the manifold block within the specified ambient and hydraulic fluidtemperature range.▶ The max. permissible temperature of 80 °C of the hydraulic fluid must not beexceeded.▶ Comply with the admissible ambient temperature range of –20 °C to +50 °C.▶ The manifold block must not be directly exposed to radiated heat.Explosion hazard caused by spark formation due to foaming hydraulic fluid!Foaming hydraulic fluid could contain a potentially explosive atmosphere that canbe ignited by a mechanical spark.▶ Prevent foaming of the hydraulic fluid.▶ Monitor the level of hydraulic fluid in the tank.▶ Prevent the ingress of air into the hydraulic system.▶ Route return lines below the minimum oil level back to the tank.Non-compliance with functional safety!Manifolds control movements in machines or systems. In the case of mechanicaland electrical faults, e.g. failure of the power supply, persons may get caught,hurled or crushed by the installation due to incorrect activation and unexpectedstarting.▶ When setting up your circuit, observe functional safety, e.g. according to EN ISO13849.▶ If necessary, fit light barriers or safety guards.▶ Replace defective components immediately. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved