Menu
Bosch PCH615FAU Instructions Manual
                   |
ConnectionInstallation continuedElectrical:An electrical 10 amp socket needs to be within 1 m of theaccessible after installation of the appliance.Important note:This appliance is connected to the mains (240 VAC) by meansof the connecting lead which must be fixed to the kitchen unitto prevent it from coming into contact with hot parts of the hobGas:During the planning stage, consider the position of supplyThe hob must be connected to the gas supply with upstreamconnection of an isolation valve in accordance with the respec-tively valid regulations. We recommend that the isolation valvebe fitted prior to the cooktop to enable isolation of cooktopfrom gas supply. The valve must be easily accessible at alltimes.To find out the factory set gas type, see bottom of cooktop nextto gas connection.Remove plastic cap from gas supply line prior to installation.Direction of gas flow is indicated on the rear of the regulator.Use pipe compound or thread sealant, properly theaded pipesand careful assembly procedure so that there is no crossthreading, etc., which might cause damage or leakage.Make sure that all connections peformed are free of leakage.In either of the cases, do not move or twist the L-tube from itsfactory-set position.If for some reason, the L-tube should be twisted, it is necessaryto make sure that this area is properly sealed. Make sure thatall connections performed are free of leakage.The manufacture does not accept any liability for leakage onNatural gas connectionPressuretest pointR 1/2”Pressuretest point.5R 1 /2”or twisted.connections.6Fit regulator (N.G.) or a test point (Universal LPG) directly toR1/2" connection as per Fig. 5. and Fig. 6.theconnections performed by the installer or if the L-tube is movedUniversal LPG connection(or an oven installed underneath) and remain accessible afterinstallation of the cooktop. When making this connection makesure that the lead cannot come into contact with hot partshotplate to allow electrical connection. The socket must remainof the hob.Important: This appliance must be earthed. When connectingthe cooktop ensure that the earth wire is connected first andthat all wires are connected to the correct terminals.For position of the inlet connection refer Fig.1.9 |
Related manuals for Bosch PCD615CAU
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved