Bosch MS 6 Manual

Also see for MS 6: Instruction manual Instruction manual User manual Instruction manual Instruction manual

Prepare Data Base | 4Bosch Motorsport Engine_Control_Unit_MS_6.x_Manual 33 / 764 Prepare Data BaseUsing RaceCon, the data base is already generated and the modification may start imme-diately. For information, please see RaceCon manual.ModasSport uses the two MS 6 programs MS6a_xxxx_yyyy_data.s19 andMS6a_xxxx_yyyy_ms_a2l for work folder generation.For help, please follow the Modas Sport manual instructions.4.1 Initial Data ApplicationThe following chapter deals only with the main parameters which should be checked be-fore a first engine startup. Several functions are recommended to be switched off, manysoftware labels will not be explained in detail. To work on these functions and labels afterthe first startup, please refer the full-scope function description. The offline data applica-tion guide shall help to get the engine started the first time without problems.CAUTIONWrong engine setup data may lead to serious engine damages.4.1.1 Basic Engine DataThe MS 6 system can be used for engines up to 12 cylinders. Please ensure that the cor-rect software variant is loaded in your ECU. Define the engine parameters like number ofcylinders, firing order, injection system and cam- and crankshaft designs in relation toTDC.4.1.2 Crank- and Camshaft WheelThe system initially supports wheels with 60-2 teeth. Other configurations in the limitsbetween 30- and 60 teeth may be possible to configure also. Please refer also to thechapter Ignition Trigger Wheel [} 23].Main Data Labels to configure for crank- and camshaft wheelCRANK_TOOTH_CNT Number of teeth of the flywheel (including the missingteeth) (limited to 30-60 teeth)CWINTF_CRANK Selection of used crankshaft sensor type (Hall or induct-ive type)CRANK_GAP_TOOTH_CNT Number of missing teeth on the flywheelCAM_MODE Camshaft position detection modeCAM_TOOTH_CNTx Number of teeth on the camshaftCAM_POS_EDGESx Position [°CRK] of positive camshaft edgesCAM_NEG_EDGESx Position [°CRK] of negative camshaft edges (onlinemeasurement, see channels cam_neg(pos)_edges_xxx)ANG_CAM_CATCHx Max. deviation of cam edges angles allowedSYNC_CAM Camshaft signal used for engine synchronization