Bosch HMV3052C Installation Manual

Also see for 300 Series: Installation manual Use and care manual Use and care manual Use and care manual Operating instructions

Contents

115. Confirm that the plate is properly centered and level.6. Securely tighten all screws, including the fifth woodscrew in the bottom area of the mounting plate.Attaching the mounting plate (wall stud at one cornerhole)1. Insert the bolts and the wood screws into the mountingplate through the holes designated.2. Attach toggle wings from the back of the mountingplate onto each bolt. Leave enough space for togglewings to go through the wall and to open.3. Place the mounting plate against the wall and makesure tabs are touching the bottom of the cabinet or thelevel line (see "Aligning the mounting plate").4. Push the bolts through the drywall and finger tightenthe bolts to make sure toggle wings have openedagainst drywall.5. Confirm that the plate is properly centered and level.6. Securely tighten all screws and bolts.Attaching the mounting plate (wall studs at both cornerholes)1. Insert the wood screws into the mounting platethrough the holes designated.2. Place the mounting plate against the wall and makesure tabs are touching the bottom of the cabinet or thelevel line (see "Aligning the mounting plate").3. Confirm that the plate is properly centered and level.4. Securely tighten all screws.Adapting microwave blowerThis microwave is shipped assembled for Room VentingInstallation. The blower unit is already in place and mustnot to be adapted.Adapting microwave blower for roof venting1. Remove and save the screws holding the blowermotor and the blower plate. Lift up the blower plateand put it aside.2. Carefully pull out the blower unit and rotate 90º so thatfan blade openings are facing out the top of themicrowave.3. Place the blower unit back into the opening.9 CAUTIONDo not pull or stretch the blower unit wiring. Makesure the wires are not pinched, and that they areproperly secured.4. Replace the blower plate and secure with the screwsremoved in step 1.5. Attach the exhaust adapter to the top of the blowerplate by sliding it into the guides. Push in securely untilit is in the locking tabs. Make sure the damper hingeswings freely.