Bosch HMV3052C Installation Manual

Also see for 300 Series: Installation manual Use and care manual Use and care manual Use and care manual Operating instructions

Contents

10Attaching the mounting plate to the wallAligning the mounting plate9 CAUTIONWear gloves to avoid cutting fingers on sharpedges.Note: Make sure the cabinet bottom is level.1. Draw a vertical line on the wall at the center of thecabinet space.2. Use the mounting plate as a template and place it onthe wall, making sure that the tabs are touching thebottom of the cabinet or the level line.3. Line up the notch and centerline of the mounting plateto the centerline on the wall.4. While holding the mounting plate, draw circles on thewall at holes A, B, C and D.Note: If neither A, B, C nor D is in a stud, find a studsomewhere in the bottom area of the mounting plateand draw a fifth circle to line up with the stud.It is important to use at least one wood screw mountedfirmly in a stud to support the weight of the microwave.5. Set the mounting plate aside.6. Drill holes on the circles:▯ 3/16” (5 mm) holes for wood screws (stud)▯ 5/8” (16 mm) holes for toggle bolts (no stud)Attaching the mounting plate (no wall studs at cornerholes)1. Insert the bolts into the mounting plate through theholes designated.2. Attach toggle wings from the back of the mountingplate onto each bolt. Leave enough space for togglewings to go through the wall and to open.3. Place the mounting plate against the wall and makesure tabs are touching the bottom of the cabinet or thelevel line (see "Aligning the mounting plate").4. Push the bolts through the drywall and finger tightenthe bolts to make sure toggle wings have openedagainst drywall.$ %'&$ %'&