Bosch FPC-500-2 Installation Manual

Also see for FPC-500-2: Operation guide Quick installation guide

Installing the HousingUse the panel housing to draw drill holes at the desired locationon the wall (arrows in figure below). As an option, you can usethe mounting dimensions indicated on the back of the housing.Ensure that the housing is aligned horizontally and draw on theholes using the built-in spirit level in the upper left corner. Thedimensions can be taken from the drilling jib on the rear of thehousing. Drill the holes.Guide the cables routed under plaster through the punched outcable ducts on the rear of the housing into the housing. Mountthe housing to the wall using screws. Make sure that cables arenot pinched.Then guide the cables routed on plaster through the cableentries to the upper side of the housing.3x(• 8 x 40 mm)3x• 6 x 50 mmPZ3S83x• 6 x 50 mmPZ3• 8mmPZ33x(• 8 x 40 mm)3x• 6 x 50 mmPZ3S83x• 6 x 50 mmPZ3• 8mmPZ33.2.3Conventional Fire Panel Installation | en 15Bosch Sicherheitssysteme GmbH 2014.06 | 7.0 | F.01U.172.980