OneStart

Menu
Bosch DIVAR IP 7000 1U Installation Manual Manual pdf 21 page image

Bosch DIVAR IP 7000 1U Installation Manual

Also see for DIVAR IP 7000 1U: Quick installation guide

Page 1 previewPage 2 previewPage 3 previewPage 4 previewPage 5 previewPage 6 previewPage 7 previewPage 8 previewPage 9 previewPage 10 previewPage 11 previewPage 12 previewPage 13 previewPage 14 previewPage 15 previewPage 16 previewPage 17 previewPage 18 previewPage 19 previewPage 20 previewPage 21 previewPage 22 previewPage 23 previewPage 24 previewPage 25 previewPage 26 previewPage 27 previewPage 28 previewPage 29 previewPage 30 previewPage 31 previewPage 32 previewPage 33 previewPage 34 previewPage 35 previewPage 36 previewPage 37 previewPage 38 previewPage 39 previewPage 40 previewPage 41 previewPage 42 preview
Contents
  1. Table Of Contents
  2. Table Of Contents
  3. Safety precautions
  4. Electrical safety precautions
  5. ESD precautions
  6. Important notices
  7. System overview
  8. Backplane
  9. Control panel buttons
  10. Power supply LEDs and overheat indicators
  11. Inserting hard disks
  12. Rack installation
  13. General system precautions
  14. Rack mounting instructions
  15. Installing the inner rails
  16. Installing the outer rails to the rack
  17. Installing the chassis into the rack
  18. Installing the chassis into a Telco rack
  19. System setup - first steps
  20. Using Bosch VMS Config Wizard
  21. Adding additional licenses
  22. Installing additional drives
  23. Adding and formatting the VHD as a VRM target
  24. Connecting to the internet
  25. Installing an Enterprise Management Server
  26. Recovering the unit
  27. Additional documentation and client software
  28. Appendices
  29. Motherboard component overview
  30. Motherboard features
  31. Block diagram
  32. PC health monitoring
  33. Power supply
  34. Overview of the Nuvoton BMC controller
Bosch DIVAR IP 7000 1U Installation Manual Manual pdf 21 page image
System setup - first stepsThe following installation directive provides information on Installation and Configuration.This chapter is valid for DIVAR IP models that come with pre-installed hard drives. Empty unitsstart into the DOM recovery menu on first start. The recovery process is described in theinstallation manual.See also:– Recovering the unit, page 29IntroductionDIVAR IP systems are shipped with a pre-installed Configuration Wizard from factory.Setup instructionAll DIVAR IP systems are preconfigured with a default IP address and with default iSCSIsettings.– IP Address: 192.168.0.200– Subnet mask: 255.255.255.0Observe the following:– DIVAR IP needs to have an active network link during installation. Make sure that thenetwork switch you are connecting to is powered on.– The default IP address must not be occupied by any other device in the network. Makesure that the default IP addresses of existing DIVAR IP systems in the network arechanged before adding another DIVAR IP.– Determine whether the initial installation is on a DHCP network. If not then you mustassign valid IP addresses to the video devices. Consult the local IT administrator to obtaina valid IP address range to be used with DIVAR IP and associated devices.– The default iSCSI settings are optimized for use with Bosch VMS/VRM.User with administrator rights:– User: BVRAdmin– Password: WSS4BoschNotice!We strongly recommend not changing the user settings. Changing the user settings can resultin malfunctioning of the system.Starting the applicationDIVAR IP system is ready to go out of the box. The application provides a simple to install andintuitive to use solution for network surveillance systems.To start the application:1. Connect the unit and the cameras to the network.2. Turn on the unit.The Windows Server 2008 R2 setup process starts.3. Select the appropriate language for the installation, then click Next.4. In the Country or region, Time and currency and Keyboard layout lists, click theappropriate item, then click Next.The Microsoft Software License Terms and the EULA (End User License Agreement) aredisplayed.5. Accept the license terms, then click Start. Windows restarts.After restart is finished, different Bosch VMS versions are displayed on the screen.55.15.25.3DIVAR IP 7000 1U System setup - first steps | en 21Bosch Sicherheitssysteme GmbH Installation Manual 2014.12 | V3 | DOC
/ 42
This manual is suitable for:
DIVAR IP 7000 1U
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved