Bosch DIP-7040-00N Quick Installation Manual

Also see for DIVAR IP 7000 1U: Installation manual

Finish configuration pageAfter clicking Save and activate the configuration is activated.After successful activation the Activate Configuration page is displayed again. Now you canstore a backup of the configuration if desired: Click Save backup copy.Using Bosch VMS Configuration ClientIf the IP addresses of devices that should be added do not fall within the same IP range as theDIVAR IP, we recommend using the Bosch VMS Configuration Client.To assign device IP addresses:1. On the Bosch VMS default screen, double-click the Configuration Client icon tochange device network settings. The application starts.2. Enter the following, then click OK.User name: adminPassword: no password required (if not set with the wizard)Connection: 127.0.0.13. On the Hardware menu, click Initial Device Scan.The application performs a network scan for all defaulted devices.4. To assign all devices at once, click Select All, then right-click the selected devices, thenclick SetIP Addresses. The Set IP Addresses dialog box is displayed.Note:It is also possible to configure the devices individually with specific IP addresses basedon MAC address.5. Enter the starting IP address for the address range you want to use, click the Calculatetab, then click OK.6. To restart the devices, click OK.7. Close Configuration Client .4.5DIVAR IP 7000 1U System setup - first steps | en 27Bosch Sicherheitssysteme GmbH Quick Installation Guide 2013.10 | V1 | DOC