Bosch CSG7364B1 User Manual And Installation Instructions

Also see for 8 Series: Instruction manual Recipes Instruction manual Installation instructions Assembly instructions

en Home Connect26Personalisa-tionSelectionChildprooflock¡ Button lock only1¡ DeactivatedAutomaticrapid heating¡ off¡ On11 Factory setting (may vary according to model)Factory set-tingsSelectionFactory set-tings¡ RestoreInfo DisplayAppliance in-formationDisplay technical information aboutthe appliance.16.2 Changing the basic settings1. Press "Basic settings" in the menu.2. Press the required basic settings area.3. Press the required basic setting.4. Press to select the required basic setting.a The change is applied directly for most basic set-tings.5. To change additional basic settings, use to goback and select a different basic setting.6. To exit the basic settings, use to go back to themain menu or switch off the appliance using .a The changes are saved.Note: Your changes to the basic settings will be re-tained even after a power failure.16.3 Setting the time1. Press "Basic settings" in the menu.2. Press "Time".3. To set the time, press the hour display or the minutedisplay.a The selected value is marked in blue.4. Use the setting ring to set the time.‒ The minutes are counted in 5-minute increments.To set it to the precise minute, press and holdthe corresponding area in the setting ring foraround 1-2 seconds. The minutes are shown indots. Use the setting ring to set the minutes.5. To exit the basic settings, use to go back to themain menu or switch off the appliance using .a The time is saved.Home Connect17 Home ConnectThis appliance is network-capable. Connecting your ap-pliance to a mobile device lets you control its functionsvia the Home Connect app, adjust its basic settingsand monitor its operating status.The Home Connect services are not available in everycountry. The availability of the Home Connect functiondepends on the availability of Home Connect servicesin your country. You can find information about this at:www.home-connect.com.The Home Connect app guides you through the entirelogin process. Follow the instructions in the Home Con-nect app to configure the settings.Tip: Please also follow the instructions in theHome Connect app.Notes¡ Please note the safety precautions in this instructionmanual and make sure that they are also observedwhen operating the appliance via the Home Con-nect app.→ "Safety", Page 2¡ Operating the appliance on the appliance itself al-ways takes priority. During this time it is not possibleto operate the appliance using the Home Connectapp.¡ In networked standby mode, the appliance requiresa maximum of 2 W.17.1 Setting up the Home Connect app1. Install the Home Connect app on your mobiledevice.2. Start the Home Connect app and set up access forHome Connect.The Home Connect app guides you through the en-tire login process.17.2 Setting up Home ConnectRequirements¡ The appliance is connected to the power supply andis switched on.¡ You have a mobile device with a current version ofthe iOS or Android operating system, e.g. a smart-phone.¡ The Home Connect app has been installed on yourmobile device.¡ The appliance is receiving signals from the WLANhome network (Wi-Fi) at its installation location.¡ The mobile device and the appliance are withinrange of your home network's Wi-Fi signal.1. Open the Home Connect app and scan the follow-ing QR code.2. Follow the instructions in the Home Connect app.