Bosch CM710B Installer's Reference Manual

P/N: CM710BIRG Rev 1.3 Page  3Copyright © 2012 E&OEModule Address Switches and Output NumberingTable 2: and Table 3: list the module address settings and corresponding output numbers that apply when addingoutput expanders to the listed panels. Each output expander module added to the Solution 16i will provide a maxi-mum of 4 additional outputs.iNoteOnly one CM710B can be assigned to each address. All mod-ules are supplied from the factory set to address 1. You mustpower cycle the panel or perform a LAN scan whenever youchange the module address. The LAN must be in the unlockedstate or the LAN scan will not find new modules.Panel Output AssignmentsThe following tables list the output numbers which become available when adding output expander modules to thesystem.Solution 16i PanelModuleNumberAddress Setting OutputNumbersSW1 SW2 SW3 SW4Control Panel 1 to 41 = OFF OFF OFF OFF 5 to 81 x CM710B can be fitted to the Solution 16i panel.Table 2: CM710B Address Configuration On Solution 16i PanelSolution 144 and Solution E PanelsModuleNumberAddress Setting OutputNumbersSW1 SW2 SW3 SW4Solution 144 PanelSolution E PanelControl Panel 1 to 5Virtual Outputs 6 to 81 = OFF OFF OFF OFF 9 to 122 = ON OFF OFF OFF 13 to 163 = OFF ON OFF OFF 17 to 204 = ON ON OFF OFF 21 to 245 = OFF OFF ON OFF 25 to 286 = ON OFF ON OFF 29 to 327 = OFF ON ON OFF 33 to 368 = ON ON ON OFF 37 to 409 = OFF OFF OFF ON 41 to 4410 = ON OFF OFF ON 45 to 4811 = OFF ON OFF ON 49 to 5212 = ON ON OFF ON 53 to 5613 = OFF OFF ON ON 57 to 6014 = ON OFF ON ON 61 to 6415 = OFF ON ON ON 65 to 6816 = ON ON ON ON 69 to 72Up to 16 x CM710B can be fitted to the Solution E panel.Up to 8 x CM710B can be fitted to the Solution 144 panel.Table 3: CM710B Address Configuration On Solution E and Solution 144 PanelsONPositionFigure 1: Address Switch Activation