Bosch FPC 7034 Manual

Contents

power requirements

Fire Alarm Systems | FPC-7034 IDC expander, 4-pointFPC-7034 IDC expander, 4-pointwww.boschsecurity.comu Adds four Class B or two Class A initiating circuitsto the FPD‑7024 FACPu For use with normally‑open (NO) or normally‑closed(NC) alarm contactsu Compatible with two‑wire or four‑wire smokedetectorsu Up to 20 two‑wire smoke detectors per circuitu Easy installation due to plug‑in design and screwterminal circuit connectionsThe FPC‑7034 Four-point Expander doubles thenumber of alarm initiating device circuits on theFPD‑7024 Fire Alarm Control Panel (FACP). Thesecircuits are identical to the circuits on the FACP.This plug‑in module is automatically recognized by thecontrol panel's firmware when power is restored tothe system.Certifications and approvalsRegion Regulatory compliance/quality marksUSA UL UL 864, Control Units and Accessoriesfor Fire Alarm SystemsFM FPC-7034CSFM see www.boschsecurity.com (the Boschwebsite)FDNY-CoA 6173Installation/configuration notesCompatible ProductsThe FPC‑7034 is compatible with the FPD‑7024 FACPs.For a list of compatible smoke detectors, see the FPD7024 Smoke Detector Compatibility List Technogram.NoticeWhen four‑wire smoke detectors are used, powermust be supplied to the detectors from either thecontrol panel or an external power source.Mounting ConsiderationsThe FPC‑7034 mounts on the FPD‑7024 control board,just to the right of the keypad. Use the four nylonstand‑offs supplied with the expander.Initiating Circuit WiringCircuit connection for the expansion initiating circuitsis identical to the on‑board circuit configuration. Forwiring details, see the FPD‑7024 Installation Guide.Install a supplied EOL resistor at the end of eachwiring run.Parts includedQuantity Component1 Four-loop expander board4 2.21 kΩ End‑of‑Line (EOL) resistors (P/N: 25899)

/ 2

Related manuals for Bosch FPC 7034