Black & Decker BDI200 Instruction Manual

Contents

27Common Power Output ProblemsPossible Causes RecommendationsBattery voltage below 10.5 volts Recharge battery or check DC power supply.Equipment being operated draws too much power Reduce load to maximum 200 watts.Inverter in thermal shutdown condition Allow inverter to cool down. Ensure there is adequateventilation around the unit, and the load is no morethan 200 watts for continuous operation.AC output is shorted Unplug the AC appliance. Disconnect the unit fromany 12 volt DC power source, then reconnect the unitBEFORE plugging the appliance back in.SERVICE INFORMATIONBlack & Decker offers a full network of company-owned and authorized service locations. AllBlack & Decker Service Centers are staffed with trained personnel to provide customers withefficient and reliable power tool service. Whether you need technical advice, repair, or genuinefactory replacement parts, contact the Black & Decker location nearest you.SPECIFICATIONSMaximum Continuous Power: 200 WattsSurge Capacity: 400 WattsUSB Output: 5 V DC (500mA)Input Voltage: 12.8 voltsLow Voltage Alarm: 11.0 ± 0.3 volts DCLow Voltage Shutdown: 10.5 ± 0.3 volts DCThermal Shutdown: AutomaticWave Form: Modified Sine Wave (MSW)Fuses: Internal: 25 Amps/DC Accessory Plug: 8 AmpsInput Cables: Battery clip cables and 12V Accessory PlugOperating Temperature: 10-20°C (50-68°F)Storage Temperature: 0-40°C (32-104°F)Operating/Relative Humidity: 5-95% non-condensing

/ 28

Related manuals for Black & Decker BDI200