Black & Decker ATM100 Instruction Manual

EEEE XXXX TTTT EEEE NNNN DDDD EEEE RRRR tttt mmmmTTTTAAAA PPPP EEEE MMMM EEEE AAAA SSSS UUUU RRRR EEEE ---- AAAATTTTMMMM111100000000 IIIINNNNSSSSTTTTRRRRUUUUCCCCTTTTIIIIOOOONNNN MMMMAAAANNNNUUUUAAAALLLLBEFORE YOU CALL, HAVE THE FOLLOWING INFORMATION AVAILABLE, CATALOG No., TYPE No., AND DATE CODE. IN MOST CASES, ABLACK & DECKER REPRESENTATIVE CAN RESOLVE THE PROBLEM OVER THE PHONE. IF YOU HAVE A SUGGESTION OR COMMENT,GIVE US A CALL. YOUR FEEDBACK IS VITAL TO BLACK & DECKER.WARNING: READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all instructions listed below, may result in personal injury.SAVE THIS MANUAL FOR FUTURE REFERENCE.BEFORE RETURNING THIS PRODUCT FOR ANY REASON PLEASE CALL1-800-544-6986Installing the BatteriesRemove the battery compartment cover as shown in figure 1. Insert four fresh AAA batteries makingsure to match (+) and (-) terminals correctly. Replace the battery compartment cover.WARNING: Batteries can explode, or leak, and can cause injury or fire. To reduce this risk:• Carefully follow all instructions and warnings on the battery label and package. • Always insertbatteries correctly with regard to polarity (+ and -), marked on the battery and the equipment. • Donot short battery terminals. • Do not charge batteries. • Do not mix old and new batteries. Replaceall of them at the same time with new batteries of the same brand and type. • Remove dead bat-teries immediately and dispose of per local codes. • Do not dispose of batteries in fire. • Keep bat-teries out of reach of children. • Remove batteries if the device will not be used for several months.“Transporting batteries can possibly cause fires if the battery terminals inadvertently come in contact with conductive materials suchas keys, coins, hand tools and the like. The US Department of Transportation Hazardous Material Regulations (HMR) actually pro-hibit transporting batteries in commerce or on airplanes (i.e. packed in suitcases and carryon luggage) UNLESS they are properlyprotected from short circuits. So when transporting individual batteries, make sure that the battery terminals are protected and wellinsulated from materials that could contact them and cause a short circuit.”OperationWARNING: Always use proper eye protection.To extend the tape, press the forward arrow asshown in figure 2.To retract the tape, press the rearward arrow asshown in figure 3. Retract tape slowly.WARNING:• Avoid tape while it is extending or retracting asinjury is possible.• Do not operate in explosive atmospheres, such asin the presence of flammable liquids, gases, or dust.• Store idle product out of reach of children.• Do not allow to be used as a toy. Close attention isnecessary when used by or near children. Notrecommended for use by children.• Hold tool by insulated gripping surfaces. Contactwith “live” wires will also make exposed metal partsof the tool “live” and shock the operator.Service InformationAll Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service.Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black & Decker location nearest you. Tofind your local service location, refer to the yellow page directory under "Tools—Electric" or call: 1-800-544-6986 or visitwww.blackanddecker.comFull Two-Year Home Use WarrantyBlack & Decker (U.S.) Inc. warrants this product for two years against any defects in material or workmanship. The defective product willbe replaced or repaired at no charge in either of two ways.The first, which will result in exchanges only, is to return the product to the retailer from whom it was purchased (provided that the store isa participating retailer). Returns should be made within the time period of the retailer’s policy for exchanges (usually 30 to 90 days afterthe sale). Proof of purchase may be required. Please check with the retailer for their specific return policy regarding returns that arebeyond the time set for exchanges.The second option is to take or send the product (prepaid) to a Black & Decker owned or authorized Service Center for repair orreplacement at our option. Proof of purchase may be required. Black & Decker owned and authorized Service Centers are listed under"Tools-Electric" in the yellow pages of the phone directory.This warranty does not apply to accessories. This warranty gives you specific legal rights and you may have other rights which vary fromstate to state or province to province. Should you have any questions, contact the manager of your nearest Black & Decker ServiceCenter. This product is not intended for commercial use.FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call 1-800-544-6986 for a freereplacement.123See ‘Tools-Electric’– Yellow Pages –for Service & SalesImported byBlack & Decker (U.S.) Inc.,701 E. Joppa Rd.Towson, MD 21286 U.S.A.

/ 2

Related manuals for Black & Decker ATM100