Black & Decker 79-362 Instruction Manual

DDDD oooo oooo rrrr LLLL oooo cccc kkkk IIII nnnn ssss tttt aaaa llll llll aaaa tttt iiii oooo nnnn KKKK iiii ttttINSTRUCTION MANUALINCLUDED IN THIS KIT:2-1/8 in. Wood Hole Saw1 in. Wood Hole SawWood ChiselGuideMandrel3/8 in. or largerDrillHammerWood ChiselScrewdriverTape MeasureBACKSETFACEBORELATCHBOREDOORTHICKNESSWARNING: Failure to read and follow all instructionslisted below may result in serious injury or propertydamage.• Read and follow all instructions in drill manual and on hand tools.• Always use proper eye, respiratory and hearing protection.• For use only on wood doors. DO NOT use on metal doors.Steps to Install Door Lock Kit:1. Locate and tighten guide on door• Determine location of door lock by measuring up from bottom ofdoor and making a mark on the latch bore side of door.*Exact measurement depends on door lock, consult doorlock manual.• Hold guide with black latch faceup, closest to you. Using 2hands, pull open guide. Slide theblack latch from right to left until itclicks. Line up the black cylinderon the latch bore side of door soyour mark is in the middle. Besure the black cylinder is flushagainst the door. Using 2 hands,clamp the guide securely on thedoor.NOTE: Clamping the guide willautomatically center the latch bore cylinder.2. Drill Face and Latch Bore HolesFACE BORE• The guide provides the ability to drill your face bore hole at 2different backsets of 2-3/8 in. (60mm) and 2-3/4 in. (70mm)). Theguide is set at 2-3/8 in. (60mm).*If this is not your preference, pull out the inserts and rotate them90 degrees and re-insert.• Assemble the 2-1/8 in. hole sawby screwing the mandrel into thehole saw.• Drill the face bore hole usingthe guide as a reference.Continue drilling until the mandrelhas drilled through to the otherside of the door (do not push thehole saw through to the otherside, it could splinter the door).• Drill hole on other side usingthe pilot hole as a starting point.LATCH BORE• Disassemble 2-1/8 in. hole saw and assemble 1 in. hole saw.• Drill hole with 1 in. hole saw through latch bore guide hole.Drill hole completely through to face bore hole.• Remove guide from door by sliding black latch to the right andpulling guide apart.3. Install Door Lock• Follow instructions providedwith door lock for lock setinstallation.REFERENCEGUIDE:TOOLS REQUIRED:Catalog # 79-362

/ 3

Related manuals for Black & Decker 79-362