R5906112-06 UDX series96Source signal AutoStereo Mono ActiveStereo2D Source Output is a 2D image Output is a 2D image Output is in Active StereoActive Stereo source Output is in Active Stereo Output is a 2D image Output is in Active StereoPassive Stereo source Output is in Active Stereo Output is a 2D image Output is in Active StereoWhen a different Display Mode is chosen compared to the source signal (e.g. Active Stereo sourcewith Mono output), advanced image processing will make sure you a desirable image will bedisplayed.How to select the desired projection method?1. In the main menu, select Installation → Display Setup.Image 8-59: Installation menu, Display setupThe Display setup menu is displayed.2. Select the desired Display Mode:• AutoStereo (default value)• Mono• ActiveSteroImage 8-608.8.5 3D emitter SetupWhy change the 3D setup?While Barco provides a 3D emitter and active shutter glasses as options to this projector, you are free to use a3D emitter and active shutter glasses of your own choice. Since glasses and emitter can have variousspecifications compared to the ones Barco provides, the 3D setup menu allows you to configure the outputimage to the specifications of your glasses and emitter. The following can be configured:• Swap Eye: You can choose to invert the stereo Sync.• Dark time: You can select how much dark time the projected image will have between frames. You canchoose one of the options between 1000 μs and 2500 μs.• Sync Delay: You can increase or decrease the sync delay. The scale goes from –10 000 μs to +10 000 μswith a step of 100 μs.GUI – Installation
