R5911443 /02 UDM34To activate the remote control press the on/off button.To deactivate the remote control press the on/off button again.Default when (re)placing batteries, is “ON”.1Image 3-53.4 Using the RCUPointing to the reflective screen or IR sensorsSwitch on the RCU and point the front of the RCU to the reflective screen surface or point directly to one of theprojector IR sensors. Make sure you are within the effective operating distance (30 m, 100 ft in a straight line).The RCU will not function properly if strong light strikes the IR sensor window or if there are obstaclesbetween the RCU and the IR receiver.Image 3-6The RCU can also hard-wired been used. See chapter “Using the XLR connector of the RCU”, page 36.Using the RCU in combination with a 3D emitterWhen using a 3D emitter that radiates IR beams (e. g. the optional 3D emitter that Barco provides), the IRbeams of the 3D emitter may interfere with the IR communication between projector and the RCU.If such interference occurs, connect the RCU to the projector using the remote cable with XLR connector. It isalso be advised to turn the IR receivers of the projector off to avoid the 3D emitter interference. The IRreceivers can be turned off in the GUI: System Settings > Communication > IR Control .Pulse Remote Control Unit
